INSTALLATION REQUIREMENTS

To install a Novatron solar water heater you will need;

VENT; 1 x 22mm elbow, one side female threaded, the other side easy fit.

INLET AND DRAIN ; 2 X straight connectors one side 15mm female threaded the other side easy fit the size of your inlet pipe.

OUTLET; 1 X elbow one side female threaded 22mm, the other side easy fit the size of your hot water feed pipe.

PIPE; Easy fit pipe the length necessary to connect to your inlet and outlet.

All connecters and fittings may be supplied by our installers at an extra charge.

Electricity supply (only if you are going to use the auxiliary heater) via a 3 core wire of at least 2.5mm tickness.

Note; you MUST have an ELCB in your mains electricity installation. Kindly observe goverment and enemalta rules in this regard, as this is your responsibility not ours.

CAUTION

PLEASE MAKE SURE THAT YOUR HOUSE IS PROPERLY PROTECTED BY AN ELCB, (EARTH LEAKAGE CIRCUIT BREAKER) AS THIS MAY SAVE YOUR LIFE.